Keep that in mind for storage as well as use. The rubbing alcohol is " flammable" while lighter fluid is flammable. It is highly volatile, and not pleasant to be around. I occasionally use naphtha to clean lens elements.
#Nikon d70 Patch#
If you attempt to use either chemical, test a small patch on the bottom of the camera to make sure they won't damage the plastic. In addition to removing the rubber, they can also damage the plastic on the camera body. You should also wear gloves to protect your skin. You'll need to be outside or have active ventilation if you use them. I didn't use either of these because they are strong solvents. After a few minutes of exposure to the rubbing alcohol Chemicals I Didn't Test Note- I would happily still use a D70 But still use my D200 with a Long lens & tripod. Over time I move up to a D7100 BUT- I still have a D70 which is converted for IR.
If you need to remove all of the rubber, find a piece of plastic you can scrape the rubber off with. I graduated from a Nikon 601 film camera to a D70 which I loved. This is common on the back of 35mm SRLs, like the Nikon N70. This can be due to the rubber aging, being in a hot environment, or from long exposure to sunlight (UV).įor rubber that has completely broken down, you'll have to remove all of it. The sticky grip is caused by the rubber breaking down. The 90% is more concentrated, so it carries a slightly higher risk. Just be careful if you use it on something else.Īs mentioned previously, both are flammable. It is also less likely to cause damage, such as removing a finish or printing, if use to clean/disinfect something.ĩ0% will be safe for use on a camera. I went with 70% because it was what I had on hand.ħ0% produces fewer fumes. So you could weaken the strength of what you buy with distilled water. It is used to sterilize equipment and cuts. You can find isopropyl alcohol, also known as rubbing alcohol, in the first aid section of any pharmacy. Where to Find Isopropyl Alcohol (Rubbing Alcohol) Also, be careful because both are flammable.
#Nikon d70 skin#
Wearing rubber gloves is also a good idea to prevent the skin on your hands from getting very dry. The isopropyl alcohol will give off fumes. Make sure to do this in a well ventilated area. Instead, the paper towel is going to break down and your grip will be covered by paper towel fibers.
Rubbing hard does not speed up the process. The isopropyl alcohol will slowly break down the rubber.Īfter 20-30 seconds, wipe off the grip and see if it is still sticky. Get a paper towel damp with the isopropyl alcohol and gently wipe the sticky rubber. To remove the sticky rubber, you're going to need lots of paper towels. The isopropyl alcohol will remove the rubber that has broken down and become sticky. Keep in mind, there is no fixing the rubber. It was not a quick fix, but 90% isopropyl alcohol may have worked faster. I tried half a dozen different chemicals, but the only thing that worked was 70% isopropyl alcohol (rubbing alcohol). Where to Find Isopropyl Alcohol (Rubbing Alcohol).